Using a Bus Mouse on a computer that uses an Atari or Amiga compatible joystick port:
The following is a pinout of the Logitec Bus Mouse, the Microsoft InPort Mouse should use the same pinout, minus the middle button.
Wiring according logitech documentation Pinout: 7 8 9 3 4 5 6 1 2 (looking at male end of the mouse's connector) Pin functions: Wire Mini-DIN Logitech Microsoft Atari pin Amiga pin Color Pin P-Series Signal InPort Signal number number Black 1 +5V +5V 7 7 Brown 2 X2 XA 1 2 Red 3 X1 XB 2 4 Orange 4 Y1 YA 3 1 Yellow 5 Y2 YB 4 3 Green 6 Left SW1 6 6 Violet 7 Middle SW2 - 5 Gray 8 Right SW3 9 9 White 9 GND Logic GND 8 8 SHIELD shell chassis chassis shell shellI'll add more information on this conversion later. Note I have not tested all combinations yet, there may be errors, I will correct any mistakes as I'm able to test this wiring. As of this writing, I have tested (and corrected) the Amiga wiring, and have a Logitec mouse working on the Amiga 500. I have not tried the InPort mouse as of yet, but I expect it to work the same.